EPSON EPL-N3000/AcuLaser M4000N
4.13.6 ACTUATOR FULL STACK
Removal
1.
Remove the COVER REAR. (p.362)
2.
Remove the COVER OCT. (p.364)
3.
After turning the flap of the ACTUATOR FULL STACK in the direction of the
arrow (1), release the hook of the HOUSING OCT, and move the ACTUATOR
FULL STACK in the direction of the arrow (2) to remove it from the printer body.
Installation
1.
Lift the ACTUATOR FULL STACK in the direction of the arrow (1). In this
position, engage the ACTUATOR FULL STACK with the hook, and then move it
in the direction opposite to the arrow (2) to install.
When installing the ACTUATOR FULL STACK to the printer
C H E C K
body, combine it with the SHAFT FULL STACK as shown in the
P O I N T
figure.
2.
Install the COVER OCT. (p.364)
3.
Install the COVER REAR. (p.362)
After installation, move the FLAPPER L and make sure that the
C H E C K
ACTUATOR FULL STACK operates synchronously.At the same
P O I N T
time make also sure that the FLAPPER R moves smoothly.
Disassembly and Assembly
(1)
FLAP
SHAFT FULL STACK
Figure 4- 163. ACTUATOR FULL STACK Removal
Option OCT
HOOK
(2)
ACTUATOR FULL STACK
JG3807AB
ACTUATOR FULL STACK
JG3822AA
Confidential
Revision C
367