EPSON EPL-N3000/AcuLaser M4000N
4.10 Electrical
4.10.1 SHIELD PLATE LVPS
Removal
1.
Remove the COVER REAR 500. (p.270)
2.
Remove the COVER REAR. (p.167)
3.
Remove the COVER LEFT. (p.169)
4.
Remove the COVER RIGHT. (p.168)
5.
Remove the COVER EXIT 500. (p.261)
6.
Remove the 500 EXIT ASSY. (p.262)
7.
Remove the COVER TOP, CONTROL PANEL. (p.170)
8.
Remove the COVER FRONT. (p.172)
9.
Remove the five screws (silver, 6 mm) securing the SHIELD PLATE LVPS from
the frame.
10. Remove the SHIELD PLATE LVPS.
Installation
1.
Install the SHIELD PLATE LVPS to the frame with the five screws (silver, 6mm).
2.
Install the COVER FRONT. (p.172)
3.
Install the COVER TOP, CONTROL PANEL. (p.170)
4.
Install the 500 EXIT ASSY. (p.262)
When installing it, pull the lever of the CHUTE EXIT FUSER.
C A U T I O N
5.
Install the COVER EXIT 500. (p.261)
6.
Install the COVER RIGHT. (p.168)
7.
Install the COVER LEFT. (p.169)
Disassembly and Assembly
8.
Install the COVER REAR. (p.167)
Pay attention to the difference between the two types of screws and
C A U T I O N
use them at their correct positions respectively.
9.
Install the COVER REAR 500. (p.270)
Figure 4- 92. SHIELD PLATE LVPS Removal
Electrical
Revision C
9)
10)
SHIELD PLATE LVPS
JG3178AA
Confidential
285