Epson EPL-N3000 Service Manual page 69

EPSON EPL-N3000/AcuLaser M4000N
REPLACE MAINTENANCE UNIT
The maintenance unit has reached its lifetime.
Replace the maintenance unit and then execute "Reset Maintenance Counter" in "Reset
Menu".
REPLACE FEED ROLLER C2,C3
The used amount of the paper feed roller C2 or C3 for an additional cassette has
reached its lifetime.
Replace the paper feed roller C2 or C3, and then execute "Reset C2 Counter" or "Reset
C3 Counter" in "Reset Menu".
FACE-DOWN FULL
Paper in the face-down tray has reached the defined amount. Remove paper in the face-
down tray and then press Start/Stop button to continue printing.
STACKER FULL
Paper in the shifter has reached the defined amount. Remove paper in the stacker and
then press Start/Stop button to continue printing.
W W W W OPEN
Description
W=A, B, DM. STK
The cover that indicated in W is open.
W EJL Status Bit
A or B
DM
STK
This error will be cleared by closing the corresponding cover.
Troubleshooting
Explanation
0 Cover A or B is open
1 Duplex cover is open
2 Stacker cover is open
FACEUP PATH SELECTED
Output Selection Lever is set to the Face-up tray side when printing starts in the duplex
printing mode or the Stacker is selected as the paper output destination. Return Output
Selection Lever to the Face-down side, and then press the Start/Stop button or Cancel
Job button.
Pressing the Start/Stop button forces the paper to output to the Face-down tray. Auto
continue can be applied when "Auto Cont = On" is selected.
INVALID NETWORK MODULE
No network program exists or the program for the other printer model is loaded.
Update it to one for EPL-N3000.
Auto Continue is not applied.
Each interface state will not be changed.
INVALID PS3
No PS3 program exists or the program for the other printer model is loaded.
Update it to one for EPL-N3000.
Auto Continue is not applied.
Each interface state will not be changed.
Overview
Revision C
69
Confidential