Epson EPL-N3000 Service Manual page 284

EPSON EPL-N3000/AcuLaser M4000N
Installation
1. Install the GEAR 9 to the shaft of the frame.
Install the GEAR 9 with its smaller gear end located inside.
C A U T I O N
2. Install the boss on the bottom side of the connector of the HARNESS ASSY
FUSER to the frame.
3. Install the GEAR ASSY PLATE to the frame with the four screws (silver, 6mm).
When the unsecured gear or SPRING of the GEAR ASSY PLATE
C A U T I O N
has come off, install it in the orientation shown in the figure.
4. Install the GEAR ASSY HOUSING to the frame.
When the GEAR ASSY HOUSING is removed, two of the gears
C A U T I O N
mounted on the GEAR ASSY HOUSING may come off as they are
not secured. Be careful not to drop these gears.
During installation, assemble so that the gears of the GEAR ASSY
C H E C K
HOUSING, MAIN MOTOR and GEAR ASSY PLATE engage with
P O I N T
each other securely, and make confirmation after the work. Open
the COVER OPEN, and assemble while turning the MAIN
MOTOR by hand to make the gears engage easily with each other.
5. Insert the lower boss on the connector of the HARNESS ASSY FUSER into the
frame.
6. Install the COVER LEFT. (p.169)
7. Install the FUSER ASSY. (p.253)
8. Install the COVER REAR. (p.167)
Disassembly and Assembly
Pay attention to the difference between the two types of screws and
C A U T I O N
use them at their correct positions respectively.
9. Install the COVER REAR 500. (p.270)
Frame & Drive
Revision C
284
Confidential