Epson EPL-N3000 Service Manual page 290

EPSON EPL-N3000/AcuLaser M4000N
Installation
1. Install the POWER SWITCH to the frame.
2. Fit the HARNESS ASSY AC110V to the hole of the frame rear part.
3. Fit the ground wire of the HARNESS ASSY AC110V to the frame with the one
screw (silver, with a toothed washer, 6mm).
4. Secure the HARNESS ASSY AC110V with the clamp.
5. Connect the connector (P/J48) of the HARNESS ASSY AC110V to the LVPS.
6. Connect the connector (P/J480) of the HARNESS ASSY AC110V to the POWER
SWITCH.
7. Secure the harnesses of the HARNESS ASSY AC110V with the clamp of the
GEAR ASSY HOUSING.
8. Install the SHIELD PLATE LVPS. (p.285)
9. Install the COVER FRONT. (p.172)
10. Install the COVER TOP, CONTROL PANEL. (p.170)
11. Install the 500 EXIT ASSY. (p.262)
When installing it, pull the lever of the CHUTE EXIT FUSER.
C A U T I O N
12. Install the COVER EXIT 500. (p.261)
13. Install the COVER RIGHT. (p.168)
14. Install the COVER LEFT. (p.169)
15. Install the COVER REAR. (p.167)
Pay attention to the difference between the two types of screws and
C A U T I O N
use them at their correct positions respectively.
16. Install the COVER REAR 500. (p.270)
Disassembly and Assembly Electrical
Revision C
290
Confidential