Epson EPL-N3000 Service Manual page 292

EPSON EPL-N3000/AcuLaser M4000N
Installation
1. Install the INTERLOCK S/W REAR to the frame with the one screw (silver,
6mm).
2. Secure the HARNESS ASSY INTERLOCK 2 of the INTERLOCK S/W REAR
with the clamp of the GEAR ASSY HOUSING.
3. Connect the connector (P/J44) of the INTERLOCK S/W REAR to the LVPS.
4. Install the SHIELD PLATE LVPS. (p.285)
5. Install the COVER FRONT. (p.172)
6. Install the COVER TOP, CONTROL PANEL. (p.170)
7. Install the 500 EXIT ASSY. (p.262)
When installing it, pull the lever of the CHUTE EXIT FUSER.
C A U T I O N
8. Install the COVER EXIT 500. (p.261)
9. Install the COVER RIGHT. (p.168)
10. Install the COVER LEFT. (p.169)
11. Install the COVER REAR. (p.167)
Pay attention to the difference between the two types of screws and
C A U T I O N
use them at their correct positions respectively.
12. Install the COVER REAR 500. (p.270)
Disassembly and Assembly Electrical
Revision C
292
Confidential