Epson EPL-N3000 Service Manual page 174

EPSON EPL-N3000/AcuLaser M4000N
Installation
1. Install the SWITCH I/L ASSY to the COVER TOP with the two screws (gold,
tapping, 8mm).
2. Secure the ground wire to the OPERATION PANEL with the one screw.
3. Connect the connector (P/J1) of the OPERATION PANEL.
4. Clamp the harnesses at the clamping portions of the SWITCH I/L ASSY and
OPERATION PANEL.
5. Connect the connectors (P/J144, P/J411) of the SWITCH I/L ASSY to the
connectors of the frame.
6. Install the COVER TOP to the printer body, and secure it to the COVER FRONT
with the two hooks at the front of the COVER TOP.
7. Engage the boss of the COVER OPEN with the hole of the LEVER LINK.
Engage the boss of the COVER OPEN with the hole of the LEVER
C A U T I O N
LINK, with the COVER OPEN open and the LEVER LINK
extended.
8. Install the COVER TOP to the frame with the two screws (silver, with collars,
8mm).
9. Install the 500 EXIT ASSY. (p.262)
When installing it, pass the harnesses of the MOTOR ASSY EXIT
C A U T I O N
and HARNESS ASSY EXIT SNR1 through the hole of the frame.
10. Install the COVER EXIT 500. (p.261)
11. Install the COVER RIGHT. (p.168)
12. Install the COVER LEFT. (p.169)
13. Install the COVER REAR. (p.167)
14. Install the COVER REAR 500. (p.270)
Disassembly and Assembly Cover
Revision C
174
Confidential