Epson EPL-N3000 Service Manual page 335

EPSON EPL-N3000/AcuLaser M4000N
4. Fit the SPRING BTM LOCK to the projection of the RACK BTM LOCK 550, and
install the RACK BTM LOCK 550 to the HOUSING BASE 550.
Install the RACK BTM LOCK 550 with the LEVER BTM LOCK
C H E C K
in the raised position. After installation, push down the LEVER
P O I N T
BTM LOCK and release it. When it is released, check that the
projection of the LEVER BTM LOCK comes in contact with the
stopper of the HOUSING BASE 550 and ∇ mark is located above
the stopper.
5. Install the two GEARs BTM LOCK PINION to the HOUSING BASE 550, and
engage the teeth.
Install the lower GEAR BTM LOCK PINION after installing the
C H E C K
upper GEAR BTM LOCK PINION. When installing the lower
P O I N T
GEAR BTM LOCK PINION, install it while pressing RACK BTM
LOCK 550 in the direction of the arrow as far as it goes. (NOTE 3)
6. Install the COVER BTM UP 550 to the HOUSING BASE 550 with the one screw
(gold, tapping, 6mm).
7. Fit the GEAR PB R to the SHAFT PB, and secure it to the SHAFT PB with the
hook.
Securely insert the hook of the GEAR PB R into the groove of the
C A U T I O N
SHAFT PB.
8. Install the PLATE GEAR LOCK 550 to the HOUSING BASE 550, and secure it
with the hook.
9. Secure the PLATE GEAR LOCK with the one screw (gold, tapping, 8mm).
10. Push down the PLATE ASSY BTM to have it locked.
Make sure that there is no gap between the RACK BTM LOCK 550
C H E C K
and the HOUSING BASE 550 by pressing the center part of the
P O I N T
RACK BTM LOCK 550 against the HOUSING BASE 550. (NOTE
4)
Disassembly and Assembly
NOTE3)
RACK BTM LOCK 550
NOTE4)
Figure 4- 137. GEAR LEVER LOCK, LEVER BTM LOCK Installation
Option 550 Paper Feeder
JG3205AA
RACK BTM LOCK 550
Revision C
JG3206AA
335
Confidential