Loading Roll Paper; How To Load - Epson SC-P5300 Series User Manual

SC-P5300 Series User's Guide
When printing on poster board, push the paper out
the back of the printer before printing. Therefore,
make sure the following space is secured. If the printer
is set up near a wall, make sure there is enough space
at the rear.
Paper Size Rear Space
A2 Approximately 370 mm
(approximately 14.56 in.)
Super A3 Approximately 260 mm
(approximately 10.23 in.)
A3 Approximately 200 mm
(approximately 7.87 in.)
A4 Approximately 70 mm
(approximately 2.75 in.)

Loading Roll Paper

You can load roll paper while viewing the operation
procedure on the control panel display as shown
below.
When you perform borderless printing on roll paper,
depending on the width of the roll paper, you need to
install the spacer for borderless printing provided.
Installation method U "Installing and Removing the
Spacer for Borderless Printing" on page 41
Basic Operations

How to Load

A
Press
B
Press How To... to view the loading procedure.
Follow the on-screen instructions to continue.
C
Close the roll paper cover.
D
Slide out the output tray to the second and
third extensions.
Do not raise the flap. If the flap is raised while
printing, the paper may not be ejected correctly.
40
.