Switch I/L Assy - Epson EPL-N3000 Service Manual

EPSON EPL-N3000/AcuLaser M4000N

4.2.6 SWITCH I/L ASSY

Removal
1. Remove the COVER REAR 500. (p.270)
2. Remove the COVER REAR. (p.167)
3. Remove the COVER LEFT. (p.169)
4. Remove the COVER RIGHT. (p.168)
5. Remove the COVER EXIT 500. (p.261)
6. Remove the 500 EXIT ASSY. (p.262)
7. Remove the two screws (silver, with a collar, 8 mm) securing the COVER TOP.
8. Disengage the LEVER LINK from the boss on the COVER OPEN.
Open the COVER OPEN and stretch the LEVER LINK first,
C A U T I O N
and then disengage the LEVER LINK from the COVER
OPEN.
The OPERATION PANEL mounted on the COVER TOP is
connected to the printer body with the connector. When doing
the following work, do not separate them too far.
9. Release the two hooks at the front of the COVER TOP from the COVER FRONT,
and remove and slightly separate the COVER TOP from the printer body.
10. Disconnect the connectors (P/J144, P/J411) of the SWITCH I/L ASSY from the
connectors of the frame.
11. Disconnect the connector (P/J1) of the OPERATION PANEL.
12. Remove the one screw securing the ground wire to the OPERATION PANEL, and
remove the ground wire.
13. Release the harnesses of the SWITCH I/L ASSY and OPERATION PANEL from
the clamps.
14. Remove the COVER TOP.
15. Remove the two screws (gold, tapping, 8mm) securing the SWITCH I/L ASSY,
and remove the SWITCH I/L ASSY.
Disassembly and Assembly
8)
9)
HOLE
13)
CLAMPING PORTIONS
Figure 4- 9. SWITCH I/L ASSY Removal
Cover
Revision C
COVER OPEN
7)
14)
15)
JG3007EA
Confidential
10)
173