Clutch Pr-Regi - Epson EPL-N3000 Service Manual

EPSON EPL-N3000/AcuLaser M4000N

4.11.15 CLUTCH PR-REGI

Removal
1. Remove the 550 FEEDER OPTION. (p.311)
2. Remove the six screws (gold, tapping, 8mm) securing the PLATE TIE.
3. Remove the PLATE TIE from the CHUTE OUT.
4. Disconnect the connector (P/J854) of the CLUTCH PR-REGI from the
HARNESS ASSY CLSNR1.
5. Remove the E-ring retaining the CLUTCH PR-REGI and remove the CLUTCH
PR-REGI from the ROLL ASSY TURN.
Installation
1. Install the CLUTCH PR-REGI to the ROLL ASSY TURN, and secure it with the
E ring.
When installing it, match the notch of the CLUTCH PR-REGI to
C A U T I O N
the boss of the CHUTE OUT.
2. Connect the connector (P/J854) of the CLUTCH PR-REGI to the HARNESS
ASSY CLSNR1.
Place the connected connector between the ribs of the CHUTE
C A U T I O N
OUT.
3. Install the PLATE TIE to the CHUTE OUT with the six screws (gold, tapping,
8mm).
4. Install the 550 FEEDER OPTION. (p.311)
Disassembly and Assembly
3)
WHEN ASSEMBLING
CONNECTOR
Figure 4- 123. CLUTCH PR-REGI Removal
Option 550 Paper Feeder
CHUTE OUT
4)
2)
PLATE TIE
CHUTE OUT
Revision C
CLUTCH PR-REGI
5)
JG3516AA
319
Confidential