Epson EPL-N3000 Service Manual page 179

EPSON EPL-N3000/AcuLaser M4000N
Installation
1. After inserting the hook at the front end of the RACK SIZE into the groove of the
HOUSING EXTENSION 150, turn it in the direction opposite to the arrow.
As shown in the figure, match the end of the RACK SIZE to the ∇ mark of the
2.
HOUSING EXTENSION 150, and install the RACK SIZE to the HOUSING
EXTENSION 150.
Before installing the RACK SIZE, pull out the GUIDE ASSY END
C A U T I O N
150 to the full (NOTE 1).
3. Install the COVER EXTENSION to the HOUSING EXTENSOR 150 with the
four screws (gold, tapping, 6mm).
When installing it, make certain that the COVER EXTENSION is
C H E C K
located under the three claws of the HOUSING EXTENSION 150
P O I N T
(NOTE 2). ( )
p.178
Always use the securing screws of 6mm length. If they are of 8mm
C A U T I O N
length, the HOUSING EXTENSION 150 will not operate smoothly
and the LOCK EXTENSION will not operate properly.
4. With the LINK SW SIZE 1-150, LINK SW SIZE 2-150 and LINK SW SIZE 3-150 of the
HOUSING BASE 150 pushed to the outside as shown in the figure, assemble the
HOUSING EXTENSION 150 into the HOUSING TOP 150 and HOUSING BASE 150.
Insert the two claws at the front end of the PLATE ASSY BTM into
C A U T I O N
the hooks of the HOUSING TOP 150 (NOTE 3). (
5. After securing the HOUSING TOP 150 to the HOUSING BASE 150 with the four
hooks, secure it with the two screws (gold, tapping, 8mm) in each of the left and
right sides and the six screws (gold, tapping, 8mm) in the rear side.
Disassembly and Assembly
C H E C K
P O I N T
)
p.177
150 Paper Cassette
After completion of installation, move the GUIDE ASSY END 150
to confirm that the LINK SW SIZE operates smoothly.
NOTE 1
11)
GUIDE END 150
Figure 4- 14. RACK SIZE Installation
LINK SW SIZE
Figure 4- 15. RACK SIZE Installation
Revision C
RACK SIZE
JG3009AB
JG3200AA
179
Confidential