EPSON EPL-N3000/AcuLaser M4000N
Installation
1.
Install the GUIDE ASSY CRU R.
2.
Pass the harness of the GUIDE ASSY CRU R into the hole of the frame.
3.
Secure the GUIDE ASSY CRU R to the frame with the three screws (silver,
6mm).
4.
Connect the connector (P/J15) of the HARNESS ASSY ANT to the HVPS/MCU.
5.
Connect the connector (P/J31) of the GUIDE ASSY CRU R to the HVPS/MCU.
6.
Install the DUCT FRONT, FAN SUB. (p.241)
7.
Install the SHIELD PLATE HVPS. (p.296)
8.
Install the SHIELD ASSY ESS. (p.294)
9.
Install the COVER FRONT. (p.172)
10. Install the COVER TOP, CONTROL PANEL. (p.170)
11. Install the 500 EXIT ASSY. (p.262)
12. Install the COVER EXIT 500. (p.261)
13. Install the COVER RIGHT. (p.168)
14. Install the COVER LEFT. (p.169)
15. Install the FUSER ASSY. (p.253)
16. Install the COVER REAR. (p.167)
Pay attention to the difference between the two types of screws and
C A U T I O N
use them at their correct positions respectively.
17. Install the COVER REAR 500. (p.270)
18. Install the BTR ASSY. (p.254)
Disassembly and Assembly
Xero
Revision C
258
Confidential