Installing The Roll Paper - Epson RP-U420 User Manual

Installing the Roll Paper

Use a roll paper that matches the printer's specifications. See page 10 for paper
specifications.
1. Make sure that the edge of the paper is straight, as shown on the left side
of the illustration below.
2. Turn on the printer and open the printer cover.
3. Insert the roll paper in both the receipt and journal sides of the printer.
4. For each roll, insert the tip of the paper into the paper inlet while pressing
the release lever so that the tip of the paper comes out of the paper exit.
5. If the paper was not fed far enough, press the FEED button to feed
additional paper.
6. Insert the tip of the journal paper into the groove on the take-up spool and
rotate the spool two or three times to secure the paper. Be sure that the
right side of the paper is aligned with the spool's flange.
7. Install the take-up spool and close the printer cover.
Note:
You need to replace the used roll paper with new one when PAPER OUT or
JOURNAL OUT light is on.
Stamp Button
When you want to check if a stamp is installed correctly and its print quality,
push the blue button shown below to do stamp printing.
edge of paper
release lever
RP-U420 User's Manual 7
English