Electrical - Epson EPL-N3000 Service Manual

A4 monochrome laser printer
Hide thumbs Also See for EPL-N3000:
Table of Contents

Advertisement

EPSON EPL-N3000/AcuLaser M4000N

2.5.8 ELECTRICAL

INTERLOCK S/W 24V
When the COVER OPEN is open, this safety switch shuts off the power supply of 24
VDC from the LVPS to the HVPS/MCU, MAIN MOTOR, etc.
INTERLOCK S/W 5V
When the COVER OPEN is open, this safety switch shuts off the power supply of 5
VDC from the LVPS to the LD Assembly of the ROS ASSY, etc.
INTERLOCK S/W REAR
When the COVER REAR is open, this safety switch shuts off the power supply of 24
VDC from the LVPS to the HVPS/MCU, MAIN MOTOR, etc.
FAN MAIN
To prevent abnormal temperature rise inside the printer, this fan sends out the air from
inside the printer.
FAN SUB
To prevent an abnormal temperature rise inside the printer, this fan takes in outside air.
Mounted above the ROS ASSY in the center of the Front side, this fan takes in outside
air from the Front side.
LVPS
Generates low DC voltages (5 V and 3.3 V for the logic circuits, 5 V for the
Laser Diode and 24 V for the motor and clutch) from AC power.
HVPS/MCU
The functions of HVPS and those of MCU are incorporated on one circuit board. The
HVPS circuit generates AC and DC high voltages and supplies them to the processes
for charging (BCR), development (Magnet Roll), transfer (BTR) and separation
(Detack Saw).
The MCU circuit controls printing operation based on communication with the print
controller and information sent from sensors and switches.
Operating Principles
CONTROLLER BOARD
Receives data from the host to print paper and control the whole printer.
PWBA EXIT MOTOR
Controls the MOTOR ASSY EXIT according to the signal from the HVPS/MCU.
SWITCH I/L ASSY (EPL-N3000 ONLY)
Consists of the two following safety switches:
INTERLOCK S/W 5VR
When the COVER OPEN is opened, this safety switch shuts off the power supply
of 5 VDC from the LVPS to the LD Assembly of the ROS ASSY and others.
INTERLOCK S/W Front R
When the COVER OPEN is opened, this safety switch disconnects the
INTERLOCK BEF (Front Cover Open detection signal) transmitted from the
LVPS to the HVPS/MCU.
INTERLOCK S/W REAR
PWBA EXIT MOTOR
LVPS
Figure 2-32. Major Components of the ELECTRICAL
Functions of Major Components
INTERLOCK S/W 5V
INTERLOCK S/W 24V
(EPL-N3000 only)
(EPL-N3000 only)
FAN MAIN
HVPS/MCU
FAN SUB
CONTROL PANEL (ROUGH)
Revision C
PWBA ESS
J26125EAK1
54
Confidential

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Aculaser m4000n

Table of Contents