Epson EPL-N3000 Service Manual page 288

EPSON EPL-N3000/AcuLaser M4000N
Installation
1. Install the LVPS to the frame with the five screws (silver, 6mm).
2. Connect the connectors (P/J40, P/J41, P/J42, P/J43, P/J44, P/J45, P/J46, P/J47, P/
J48) of the harnesses to the connectors of the LVPS.
3. Connect the harness connector of the LVPS to the connector of the PWBA EXIT
MOTOR.
4. Install the SHIELD PLATE LVPS. (p.285)
5. Install the COVER FRONT. (p.172)
6. Install the COVER TOP, CONTROL PANEL. (p.170)
7. Install the 500 EXIT ASSY. (p.262)
8. Install the COVER EXIT 500. (p.261)
When installing it, pull the lever of the CHUTE EXIT FUSER.
C A U T I O N
9. Install the COVER RIGHT. (p.168)
10. Install the COVER LEFT. (p.169)
11. Install the COVER REAR. (p.167)
Pay attention to the difference between the two types of screws and
C A U T I O N
use them at their correct positions respectively.
12. Install the COVER REAR 500. (p.270)
Disassembly and Assembly Electrical
Revision C
288
Confidential