EPSON EPL-N3000/AcuLaser M4000N
4.8.7 SENSOR FULL STACK
Removal
1.
Remove the COVER REAR 500. (p.270)
2.
Remove the COVER REAR. (p.167)
3.
Remove the COVER LEFT. (p.169)
4.
Remove the COVER RIGHT. (p.168)
5.
Remove the COVER EXIT 500. (p.261)
6.
Remove the CHUTE UP EXIT, CHUTE LOW EXIT. (p.263)
7.
Disconnect the connector (P/J290) of the HARNESS ASSY EXIT SNR from the
SENSOR FULL STACK.
8.
Release the hook of the SENSOR FULL STACK, and remove the SENSOR FULL
STACK from the CHUTE LOW EXIT.
Installation
1.
Install the SENSOR FULL STACK to the CHUTE LOW EXIT.
2.
Connect the connector (P/J290) of the HARNESS ASSY EXIT SNR to the
SENSOR FULL STACK.
3.
Install the CHUTE UP EXIT, CHUTE LOW EXIT. (p.263)
4.
Install the COVER EXIT 500. (p.261)
5.
Install the COVER RIGHT. (p.168)
6.
Install the COVER LEFT. (p.169)
7.
Install the COVER REAR. (p.167)
Pay attention to the difference between the two types of screws and
C A U T I O N
use them at their correct positions respectively.
8.
Install the COVER REAR 500. (p.270)
Disassembly and Assembly
7)
CHUTE LOW EXIT
Figure 4- 79. SENSOR FULL STACK Removal
500 Paper Exit
Revision C
SENSOR FULL STACK
8)
JG3083AA
268
Confidential