Roll Fu - Epson EPL-N3000 Service Manual

EPSON EPL-N3000/AcuLaser M4000N

4.8.10 ROLL FU

Removal
1. Remove the COVER REAR 500. (p.270)
2. Remove the five screws (gold, tapping, 8mm) securing the CHUTE LOW FU to
the COVER REAR 500.
3. Release the hook of the COVER REAR 500, and remove the CHUTE LOW FU
from the COVER REAR 500.
4. Release the hook of the GEAR 21, and remove it from the ROLL FU.
5. Release the hook of the BEARING EXIT, and remove it from the CHUTE LOW
FU.
Carefully handle the hook of the BEARING EXIT as it may be
C A U T I O N
damaged by application of large force.
6. Remove the ROLL FU in the direction of the arrow.
Installation
1. Move the ROLL FU in the direction opposite to the arrow, and install it to the
BEARING EXIT on the side opposite to the GEAR 21.
2. Install the BEARING EXIT to the CHUTE LOW FU.
3. Install the GEAR 21 to the ROLL FU, and secure it with the hook.
Securely insert the hook of the GEAR 21 into the groove of the
C A U T I O N
ROLL FU.
4. Install the CHUTE LOW FU to the COVER REAR 500, and secure it with the
hook.
5. Secure the CHUTE LOW FU to the COVER REAR 500 with the five screws
(gold, tapping, 8mm).
6. Install the COVER REAR 500. (p.270)
Disassembly and Assembly
BEARING EXIT
ROLL FU
COVER REAR 500
Figure 4- 82. ROLL FU Removal
500 Paper Exit
CHUTE LOW FU
6)
3)
BEARING EXIT
Revision C
5)
GEAR 21
4)
JG3100AA
271
Confidential