Power Switch, Harness Assy Ac110V - Epson EPL-N3000 Service Manual

EPSON EPL-N3000/AcuLaser M4000N

4.10.4 POWER SWITCH, HARNESS ASSY AC110V

Removal
1. Remove the COVER REAR 500. (p.270)
2. Remove the COVER REAR. (p.167)
3. Remove the COVER LEFT. (p.169)
4. Remove the COVER RIGHT. (p.168)
5. Remove the COVER EXIT 500. (p.261)
6. Remove the 500 EXIT ASSY. (p.262)
7. Remove the COVER TOP, CONTROL PANEL. (p.170)
8. Remove the COVER FRONT. (p.172)
9. Remove the SHIELD PLATE LVPS. (p.285)
10. Release the harness of the HARNESS ASSY AC110V from the hooks of the
GEAR ASSY HOUSING.
11. Disconnect the connector (P/J480) of the HARNESS ASSY AC110V from the
POWER SWITCH.
12. Disconnect the connector (P/J48) of the HARNESS ASSY AC110V from the
LVPS.
13. Remove the clamp fastening the HARNESS ASSY AC110V to release the
harness.
14. Remove the one screw (silver, with toothed washer, 6mm) securing the ground
wire of the HARNESS ASSY AC110V to the frame.
15. Pull out the HARNESS ASSY AC110V through the hole in the rear of the frame.
16. Remove the POWER SWITCH from the frame.
Disassembly and Assembly
15)
AC INLET GROUND WIRE
Figure 4- 95. POWER SWITCH, HARNESS ASSY AC110V Removal
Electrical
HOOKS
LVPS
P/J48
11)
12)
14)
13)
P/J48 CLAMP P/J480
Revision C
16)
POWER SWITCH
JG3176AA
289
Confidential