Guide Cru Left - Epson EPL-N3000 Service Manual

EPSON EPL-N3000/AcuLaser M4000N

4.7.4 GUIDE CRU LEFT

Removal
1. Remove the COVER REAR 500. (p.270)
2. Remove the COVER REAR. (p.167)
3. Remove the COVER LEFT. (p.169)
4. Remove the COVER RIGHT. (p.168)
5. Remove the COVER EXIT 500. (p.261)
6. Remove the 500 EXIT ASSY. (p.262)
7. Remove the COVER TOP, CONTROL PANEL. (p.170)
8. Remove the COVER FRONT. (p.172)
9. Remove the FUSER ASSY. (p.253)
10. Remove the BTR ASSY. (p.254)
11. Remove the GUIDE TRAY LEFT. (p.236)
12. Remove the DUCT FRONT, FAN SUB. (p.241)
13. Remove the ROS ASSY. (p.239)
Never give impact to the ROS ASSY with a screwdriver or the like.
C A U T I O N
14. Remove the SHIELD PLATE ROS. (p.243)
15. While lifting the 150 FEEDER ASSY, remove the MOTOR COVER.
16. Remove the SHIELD PLATE LVPS. (p.285)
17. Remove the MOTOR COVER. (p.277)
18. Disconnect the connector (P/J4647) of the HARNESS ASSY FUSER from the
frame.
19. Release the clamp securing the HARNESS ASSY FUSER, which comes out of the
GUIDE CRU LEFT, to the frame to release the clamped harness.
20. Disconnect the connector (P/J141) of the INTERLOCK S/W 5V from the
HARNESS ASSY LVPS.
Disassembly and Assembly
21. Disconnect the connector (P/J45) of the INTERLOCK S/W 24V from the LVPS.
22. Disconnect the connectors (P/J46 and P/J47) of the HARNESS ASSY FUSER
from the LVPS.
23. Remove the three screws (gold, 6 mm) securing the GUIDE CRU LEFT.
24. Remove the GUIDE CRU LEFT from the frame.
Remove the GUIDE CRU LEFT while simultaneously pushing the
C H E C K
LINK GEAR 3 in the direction of the arrow to make the removal of
P O I N T
the GUIDE CRU LEFT easier.
(P/J 45)
(P/J 46)
21-1)
(P/J 47)
21-2)
(p.277)
Xero
GUIDE ASSY CRU L
NOTE)
(P/J 4647)
17)
20)
22)
18)
23)
Figure 4- 62. GUIDE CRU LEFT Removal
Revision C
LINK LEVER
LINK GEAR 3
(NOTE 1)
P/J45
46
47
LVPS
JG3191AA
245
Confidential