Cutter Solenoid Assy Or Paper Guide L Adjustment; Damper Assy Adjustment; Battery - Epson Stylus Pro 7600 Service Manual

EPSON Stylus Pro 7600/9600

5.1.4.11 Cutter Solenoid ASSY or Paper Guide L Adjustment

Described below are the adjustment items to be made once the
has been replaced or the Paper Guide L has been reinstalled.
Adjusting tools:
Cutter Positioning Jig #F800
Scale 1000mm #F713
Scale Stopper #F714
Adjustment items (steps):
Table 5-13. Required Adjustment Items
Step Adjustment Item
<Mechanism Adjustment>
1 Cutter Positioning Adjustment
2 Checking for Proper Cutting and Cutter Position
<Start the Self-diagnostic Function>
[Paper Feed ∆]
(Power OFF →
→ Power ON)
3 Checking for Proper Cutting Pressure
4 Feed Correction + T&B Adjustment
Adjustment
Cutter Solenoid (p.177)
p.269
p.271
p.220
[Paper Feed ∇
+ ]+[Cut/Eject]
p.239

5.1.4.12 Damper ASSY Adjustment

Described below are the adjustment items to be made once the
has been replaced.
Execute ink discharge
C H E C K
Damper ASSY.
P O I N T
Refer to
Secure the coupling screw and the ink tube by tightening at the
specified torque. (2 ∼ 2.5 kg/f)
See
Adjustment items (steps):
Table 5-14. Required Adjustment Items (Damper ASSY)
Step
<Start the Self-diagnostic Function>
(Power OFF →
→ Power ON)
1 Including initial filling
2 Head Nozzle Checking (Cleaning)
3 Leak check pattern printing
4 Test Pattern Printing
5.1.4.13 Release Sensor (I/H Lever) Adjustment
No adjustment is required

5.1.4.14 Battery

No adjustment is required. Execute
Overview
("Ink Blowing") before removing the
"5.2.3.20 Clean Head (p.256)".
Adjustment Item
[Paper Feed ∆] [Paper Feed ∇
+ ]+[Cut/Eject]
"Initialize RTC (p.83)".
Revision A
Damper ASSY (p.173)
See
p.220
p.259
p.237
p.259
p.255
217