Removing The Cd-R Guide Assy - Epson Stylus Photo R340 Service Manual

EPSON Stylus Photo R340/350

2.3.21 Removing the CD-R Guide Assy.

Illustration (1)
Right EJ Grounding Spring
CD-R Guide Assy.
C.B.S 3x6 (6-8kgf.cm)
1
3
Ribs
Flat Washers Left CD-R Link
Flat Washer
Figure 2-79. Removing the CD-R Guide Assy. (1)
Disassembly and Assembly
Main Frame
Support Plate
Acetate Tape
2
1
C.B.S 3x6
Right Front Side
(7-9kgf.cm)
of the Printer
C.B.S 3x6 (6-8kgf.cm)
Flat Washer
2
Right CD-R Link
Ribs
Ribs
Parts/Components must be removed to remove the CD-R Guide Assy.
Paper Support Assy., Left Housing, Right Housing,
Panel Board Assy. (Panel Board and LCD Module), Upper Housing,
Rear Housing, Main Board Assy., ASF Assy., Shaft Assy. Holder,
Printer Mechanism, APG Assy., Print Head, Carriage Unit
Disassembly Procedure
1. Remove the acetate tape and release the connector cable of the Tray/CD-R
Sensor.
2. Remove the Right EJ Grounding Spring from the Main Frame and the EJ
Roller Assy.
3. Remove the two screws (
remove it.
4. Remove the three screws (
5. Remove the flat washers that secure the Left and Right CD-R Links (two
washers for each) with tweezers, then remove the Left/Right CD-R Links
from the CD-R Guide Assy.
6. Release the seven ribs ( ) that secure the CD-R Guide Assy. and remove it
first from its right side.
Disassembly
Revision A
) that secure the Main Frame Support Plate, and
) that secure the CD-R Guide Assy.
84