Hydroranger 200 Board; Board View; Installing The Battery - Siemens HydroRanger 200 Instruction Manual

HydroRanger 200 Board

Installing the Battery

The battery (Rayovac BR2032) has a ten-year life expectancy. Please note the life
expectancy may be reduced by ambient temperature. If the unit loses external and
battery power, a capacitor will power the RAM for about ten minutes.
Disconnect power before replacing the battery.
Installation Steps
1. Open the enclosure lid.
2. Slide the battery into the holder. Be sure to
align the + and – terminals correctly.
3. Close and secure enclosure lid.
All parameter values are written to the EEPROM once every hour. The
Note:
battery is used to backup Standard Data Logging parameters (P300-P321)
between writes, in case of power failure.
7ML19985FC03
TB2
2
1
RELAY 1
RELAY 2
RELAY 3
RELAY 4
RELAY 5
RELAY 6
HydroRanger 200 – INSTRUCTION MANUAL
Battery
RS-232 RJ-11
Connector
Power Supply
TB1
L2/N L1
Female Connector
TB3
SYNC
for SmartLinx Card
mA INPUT
SHIELD
SmartLinx Card
1
4 - 20 mA
OUTPUTS
2
Terminals
TS-3
SHIELD
1
2
DISCRETE
INPUTS
RS-485
COM
Connections
RS485
A
B
Battery
+
Page 13