If necessary, enter the Parameter Number to default in the Auxiliary Reading display. That
value will show in the auxiliary reading area by default. Other values are available but will
reset to the parameter defined here.
P731 Auxiliary Reading Key
Enter the Parameter Number whose value is to be displayed in the Auxiliary Reading field
Primary Index
Values
is pressed in the RUN mode. See the
P
mode auxiliary readings.
P732 Display Delay
Adjusts the Point Number display scroll speed.
Primary Index
Values
Related
Use this feature to adjust the delay before the display advances to the next Point Number.
Display scrolling is independent from transducer scanning.
P733 Scroll Access
Use this feature to select the parameter scroll access option desired.
Primary Index
Values
Press READING
indicate the parameter accessed is tagged.
Quick Start parameters (P001 – P007) and those changed from factory
Note:
default settings cannot be untagged.
Page 192
Global
Range: 000 to 999
Preset: Material Reading, P921
Global
Range: 0.5 to 10
Preset: 1.5 seconds
•
P001 Operation
•
P737 Primary Reading
Global
0
Off
1
*
Smart
2
Tagged
to tag / untag any accessed parameter.
and
HydroRanger 200 – INSTRUCTION MANUAL
Hand Programmer
section on page 26 for RUN
to scroll to all parameters (P001 to P999)
for Quick Start, altered, and tagged parameters
to scroll to operator tagged parameters only
is displayed to
7ML19985FC03