Flow Records (P320 And P321) [6 Relay Model] - Siemens HydroRanger 200 Instruction Manual

P310 Pump Hours
View or reset the accumulate ON time for the displayed Relay Number.
Primary Index
Values
Related
Value is displayed with a floating decimal point (the more figures displayed before the
decimal, the fewer displayed after). It is the value displayed when
the RUN mode.
P311 Pump Starts
View or reset the accumulated number of times the Relay Number has been ON.
Primary Index
Values
Related
This value is displayed when
P312 Pump Run Ons [6 relay model]
View or reset the accumulated number of times the displayed Relay Number has been
held ON via Run On Interval (P130).
Please note that this parameter applies to the HydroRanger 200 6 relay model only.
Primary Index
Values
Related

Flow Records (P320 and P321) [6 relay model]

Please note that these parameters apply to the HydroRanger 200 6 relay model only.
These features are enabled if Operation is set for OCM (P001 = 6), or an OCM device is
defined (P600 ≠ 0). Use them to identify the occurrence of the record high and low flow
rates as displayed in OCM Max Flow (P604) units, or as a percent of OCM Max Flow.
Press CLEAR
7ML19985FC03
Relay
Range: 0.000 to 9999
• Relay Function (P111) set for any pump control feature
Relay
Range: 0 to 9999
• Relay Function (P111) set for any pump control feature
key is pressed and held for five seconds in RUN mode.
Relay
Range: 0 to 9999
• Relay Function (P111) set for any pump control feature
keys to reset values once the installation is working correctly.
HydroRanger 200 – INSTRUCTION MANUAL
key is pressed in
Page 157