Readings In Run Mode - Siemens HydroRanger 200 Instruction Manual

Icons indicating index type (Item 1) edited in PROGRAM mode:
Icon
measurement point or transducer
relay
secondary index
mA input or output

Readings in RUN Mode

Change the displayed values with the keys on the hand programmer. All readings are
shown in the Auxiliary field, except for the totalizer and P920.
Key
+
+
[6 relay model]
[6 relay]
[6 relay]
+ ###
P
P
1.
Distances less than 0.3 m (1 ft) from the transducer face cannot be measured
reliably. Therefore, a 0% reading is not possible during Distance operation.
2.
If the associated relay is programmed for pump control.
Page 22
Index Type
Toggle Readings between percent and units:
• Level: 0 – 100%
• Space or Distance:
Accumulated pump running hours
Hold number key for five seconds to display the number of
accumulated pump starts
Eight-digit totalizer, uses index and reading areas, press
again to toggle, P737 sets default.
Used for OCM and Pumped Volume.
Head measurement
Instantaneous flow based on head (OCM)
mA Output value
Temperature
Rate of level change
Failsafe Time Left (in %). When the Reading is updated,
this value (Auxiliary Reading) resets to 100 and begins to
decrease until the next valid measurement is made. If the
Failsafe Time Left reaches 0, LOE flashes in the display.
Hold for four seconds to show echo confidence
Display the value of the entered parameter which is global
or indexed by transducer
Auxiliary reading displays parameter specified in P731
Distance
HydroRanger 200 – INSTRUCTION MANUAL
Function
1
100% – 0
2
for numbered pump.
2
for numbered pump.
P#
P920
P310
P311
P322
P323
P920
P926
P925
P203
P664
P707
P805
P731
P923
7ML19985FC03