Wiring - Siemens HydroRanger 200 Instruction Manual

Wiring

Please note:
• Verify that all system components are installed in accordance with instructions.
• Connect all cable shields to the HydroRanger 200 Shield Terminals. Avoid differential
ground potentials by not connecting cable shields to ground (earth) anywhere.
• Keep exposed conductors on shielded cables as short as possible to reduce noise
on the line caused by stray transmissions and noise pickup.
HydroRanger 200
7ML19985FC03 HydroRanger 200 – INSTRUCTION MANUAL
Siemens Milltronics
Transducer(s)
Siemens Milltronics
TS-3 Temperature
Sensor
Laptop running
Dolphin Plus
Customer Alarm,
Pump, or Control
Device
Customer Device,
digital output
Customer Device,
analog output
Customer Network or
Modem
SmartLinx Card
Display, PLC, Chart
recorder, or other
Control Device
Page 15