Siemens HydroRanger 200 Instruction Manual page 227

P908 Scanner
Press ENTER
Use this parameter to ensure that both transducers are being stimulated.
P910 Toggle Relays
Used to energize and de-energize relays directly.
Primary Index
Values
Related
Enter the relay number and then toggle between
required. Enter 0 to toggle all relays at once.
Applies only to relays with P119 = 0 (algorithm control). Use this parameter to confirm that
relay contacts are opening and closing.
This feature is helpful when P119 does not give expected results even though
programming was verified.
P911 mA Output Value
Access this parameter to display the current value of the mA output.
Primary Index
Values
Related
Additionally, this feature may be used to enter a desired value. The mA output
immediately assumes the value entered regardless of any restrictions programmed.
P912 Transducer Temperature
Use this feature to display the temperature in °C (as monitored by the connected
transducer).
Primary Index
Values
Err is displayed if the transducer is not equipped with an internal temperature sensor.
7ML19985FC03
to cycle the scanner relay while firing the transmitter.
Global
0 to 6
• P119 mA Relay Logic Test
mA output
Range: 0.10 to 25.00
• P200 mA Output Range
• P201 mA Output Function
Transducer
Range: -50 to 150
HydroRanger 200 – INSTRUCTION MANUAL
energized de-energized
and , as
Page 217