Metering; About The Meters; Viewing The Meters - RSS M-380 Owner's Manual

Metering

About the meters

The M-380 provides meters on the top panel and in the screen.
Here we will explain the METER screen, which shows the levels of
the channels.
Accessing the METER screen
1.
Press the top panel [METER] button.
The METER screen will appear.
fig.ScrMeter.eps
The content shown in the METER screen changes when you
switch tabs.
In the METER screen, the function buttons perform the
following operations.
[F1 (METER)] Accesses the METER tab,
which shows the levels of
all channels.
[F2 (LAYER VIEW)] Accesses the LAYER
VIEW tab, which shows
the levels of the same
channels as the top panel
channel layer.
[F3 (Analyzer)] Displays the Analyzer tab,
which shows the 31-band
realtime analyzer.
[F4 (NAME LIST)] Displays the NAME LIST
tab, which lists the channel
names and group names.
[F5 (PEAK CLEAR)] Clears the level meter's
peak hold or over indica-
tions.
[F6 (METER SETUP)] Accesses the METER SET-
UP popup.
94

Viewing the meters

To view the meters for all channels, use the METER tab of the
METER screen.
METER tab
fig.ScrMeterGuide.eps
2
1
4
3
1.
AUX/MAIN/MATRIX meters
These indicate the level and fader position for AUX1–AUX16,
MATRIX1–MATRIX8, MONITOR L/R, and MAIN L/R.
2.
AUX/MAIN/MATRIX meter point
This indicates the point at which the AUX/MAIN/MATRIX
meters are detecting the level.
3.
CH meters
This indicates the level and fader position for CH1–CH48.
4.
CH meter point
This indicates the point at which the CH meters are detecting
the level.
5.
Panel layer indication
The frame indicates the channel layer that is selected in the
layer section of the top panel.
The panel layer indication is not shown if the USER layer is
selected.
6.
Cursor
p. 96
This indicates the currently selected channel. You can use the
value dial to adjust the fader of the channel at the cursor
location.
When you press [SEL] to change the selected channel, the cursor
in the screen will move. When you move the cursor in the
screen, the [SEL] indication of the top panel will likewise move.
If the "CHANNEL DISPLAY follows CH SELECT button" item
in the CHANNEL SELECT section of User Preference (p. 155) is
selected, pressing a [SEL] will cause the CHANNEL DISPLAY
screen of that channel to appear.
6 5