Input Channel Operations; About The Input Channels - RSS M-380 Owner's Manual

Mixing console
Hide thumbs Also See for M-380:
Table of Contents

Advertisement

Input channel operations

About the input channels

The input channels process the audio signals from the input jacks and internal ports, and send them to the MAIN L/R bus and AUX buses.
fig.InBlkDia.eps
INPUT
PATCHBAY
CH 1-48
PREAMP
POST ATT
PHASE
ATT
FILTER
GATE
KEY-IN
INPUT PATCHBAY
This section patches input ports to input channels.
PHASE
This reverses the phase of the audio signal.
ATT (Attenuator)
This adjusts the input level in the digital domain.
FILTER
This is a 12 dB/octave filter that passes or cuts the specified
frequency range.
GATE/EXPANDER
This is a dynamics processor that can be used as a gate or
expander, or for ducking. You can use a maximum of twenty-
four units simultaneously.
COMPRESSOR
This is a dynamics processor that can be used as a compressor.
You can use a maximum of twenty-four units simultaneously.
EXT INSERT (External insert)
An external effects processor can be inserted at this point using
the rear panel CONSOLE IN1–IN8 and CONSOLE OUT1–
OUT8 jacks.
FX INSERT (Effect insert)
FX1–FX4 can be inserted at this point.
4 BAND EQ (Four-band EQ)
This is a four-band EQ with LO, LO-MID, HI-MID, and HI
frequency bands.
42
GATE IN
GATE OUT COMP OUT
PRE EQ
GR
GR
EXT FX
FX
INSERT
INSERT
GATE/
4BAND
COMP
EXP
EQ
TO
TO
COMP
KEY-IN
GATE
COMP
KEY-IN
KEY-IN
PRE FADER
POST FADER
MUTE
FADER PAN
AUX SEND 1-16
PRE EQ
PRE FADER
POST FADER
PRE EQ
PRE FADER
POST FADER
AFL SW
PFL(L)
AFL(L)
PFL(R)
AFL(R)
DIRECT OUT
PRE EQ
PRE FADER
POST FADER
MUTE
This mutes the channel. The signal sent to the MAIN L/R bus,
the AUX buses and the direct out will be muted.
FADER
This adjusts the send level to the MAIN L/R bus.
PAN
This adjusts the left/right panning of the audio signal sent to
the MAIN L/R bus.
MAIN SW (Main switch)
This turns the send to the MAIN L/R bus on/off. It does not
affect the send to the AUX buses.
AUX SEND
This adjusts the send to the AUX bus.
• DIRECT OUT POINT
This specifies the position from which the direct out signal is
taken.
MAIN
L R
MAIN
SW
AUX
SW
SEND
LINK
TO AUX
1, 3...15
PAN
SW
SEND
TO AUX
2, 4...16
SOLO
POINT
TO MAIRIX 1-8,
TO OUTPUT PATCHBAY
L R
MAIN
AUX
SOLO
1 2
16
L R
1 2
16
L R
AUX
SOLO

Advertisement

Table of Contents
loading

Table of Contents