RSS M-380 Owner's Manual page 163

5.
Use the setup display area to check the input/output unit
connections, REAC mode settings for the input/output
units, and the signal flow.
For basic knowledge about REAC, refer to "Basic knowledge
about REAC" (p. 14).
For more advanced applications of REAC, refer to "REAC
applications" (p. 157).
In some cases, a message like the following may appear after
you select MONITOR/BROADCAST A in step 4.
This confirmation message will appear if there is a difference in
sampling frequency between the FOH console (master) and the
MONITOR/BROADCAST console (split).
If you press [F8 (SET)], the cutoff frequency of the MONITOR/
BROADCAST console will be set to match that of the FOH
console.
If you press [F7 (CANCEL)], the current sampling frequency
will be maintained. If you cancel, it will not be possible to
receive the split from the FOH console.
REAC applications and settings
Checking the devices connected to
REAC A and REAC B
To view information about the devices connected to REAC A and
REAC B, you can use the REAC A tab and REAC B tab of the REAC
CONFIG popup.
1.
In the SETUP section, press [SYSTEM] to access the
SYSTEM screen.
2.
Press [F2 (REAC CONFIG)].
fig.ScrSysReacConf1.eps
The REAC CONFIG popup will appear.
3.
Press [F2 (REAC A)] (or [F3 (REAC B)]) to access the REAC
A tab (or the REAC B tab).
fig.ScrSysReacConfABGuide.eps
A
A.Device indication area
This area shows information on the devices connected to
REAC A or REAC B.
The name of the connected device, the number of inputs and
outputs, and the following information are shown.
Firmware Version Firmware version
REAC Version REAC version
B.List of displayed information
This lists the information that can be viewed for the device
connected to REAC A or REAC B. If the S-4000S is connected,
you'll be able to view the modules that are installed in SLOT1
- SLOT10.
4.
Note the information for the connected REAC device in the
device indication and the list of displayed information.
B
163