2.
LINE OUT
As the LINE OUT source, you can choose either PHONES (the
signal immediately before PHONES VOLUME), MAIN bus, or
AUX bus. This is used for a floor monitor or for two-channel
recording. Since a low-pass filter is provided on LINE OUT, it
can also be used to output just the low-frequency range to a
floor monitor or tactile transducer.
Memory functionality
The M-48 has 16 memories, and allows mixer settings to be stored or
recalled.
Memories 1–16 can be manipulated from the M-48 itself or from the
M-380 or PC.
Connecting M-48 units to
the M-380
fig.V-Mix_M48.eps
M-48
(SPLIT)
POWER
S-1608
SLAVE
REAC B
Use the REAC B port to connect M-48 units to the M-380. A
separately available S-4000D splitter and power distributor is
required in order to connect M-48 units.
The output from the M-380's REAC B port is distributed via the S-
4000D. You can connect up to four S-4000D units serially and
support up to twenty-four
M-48 units.
The mixing engineer can make settings for each M-48 unit from the
M-380.
If an M-48 unit is connected to the M-380's REAC A port or
SPLIT/BACKUP port, it will not be possible to set or manage
the M-48 from the M-380.
M-48
M-48
(SPLIT)
(SPLIT)
POWER
POWER
S-4000D
MASTER
M-380
Management of the M-48 live personal mixer
Connection examples
Here are some examples of connecting M-48 units to an M-380 that is
being used as an FOH console or as a monitor console.
fig.M48ConnectExs.eps
Connect M-48 units to the M-380
(setup as the FOH console)
(SPLIT)
S-4000S
SLAVE
fig.M48ConnectExs.eps
Connect M-48 units to the M-380
(setup as the monitor console)
S-1608
SLAVE
M-48
M-48
M-48
(SPLIT)
(SPLIT)
S-4000D
FOH CONSOLE
M-48
M-48
M-48
(SPLIT)
(SPLIT)
(SPLIT)
S-4000D
S-1608
SLAVE
FOH CONSOLE
MONITOR CONSOLE
S-1608
SLAVE
S-1608
SLAVE
185