Setting The Level, Pan, And Aux Switch For Each Source (Source Level/Pan Setting) - RSS M-380 Owner's Manual

Setting the level, pan, and
AUX switch for each source
(Source Level/Pan setting)
M-48 SOURCE LEV/PAN popup
This popup lets you set the source level and pan. Set the LEVEL,
PAN, and AUX switch for each source 1–40. Two views are
provided; the SOURCE LAYOUT tab and the M-380 LAYOUT tab.
• SOURCE LAYOUT tab
fig.ScrM48SrcLev1.eps
This shows the sources arranged in order of their number (the
order in the M-380's REAC B output patchbay).
• M-380 LAYOUT tab
fig.ScrM48SrcLev2.eps
This shows the sources as they are seen from the M-380's fader
module section. This display will change according to the M-
380's channel layer.
Nothing is shown at the position of sources that are not patched
to the REAC B output.
If the same channel is being output multiple times to REAC B,
only the lowest-numbered output will be operable.
Management of the M-48 live personal mixer
The following outputs cannot be operated in the M-380
LAYOUT tab because they do not appear in the M-380's top
panel fader module section.
• MAIN L, MAIN R, MAIN MONO
• MONITOR L, MONITOR R
• REC L, REC R
• OSCILLATOR
• TALKBACK
fig.ScrM48SrcLev_Guide.eps
3
4
1.
Target M-48 indication
This shows the unit name of the M-48 that is the target of the M-
48 SOURCE LEV/PAN.
2.
MONITOR
In this section you can make adjustments for monitoring the
mix of sources 1–40 on the M-380.
• ATT knob
This adjusts the monitor level in a range of -Inf dB – +10.0 dB.
If you turn [F6 (MONITOR)] on, the M-380's monitor output
will output the mix of sources 1–40.
The setting of the ATT knob only affects monitoring on the M-
380. It does not affect the setting of the M-48.
• Meter
This indicates the monitor output level.
3.
Source name indication
This indicates the name of the source. The source name is used
as the M-380's channel name or output name.
In the SOURCE LAYOUT tab, the names of sources for which
nothing is being output from the M-380's REAC B are not
shown; the background will be gray. In the M-380 LAYOUT tab,
channels not being output to the M-380's REAC B will have a
gray background.
4.
Number indication
In the SOURCE LAYOUT tab, this indicates the source number.
In the M-380 LAYOUT tab, this indicates the M-380's channel
number (see exceptions to the left).
1 2
5
6
7
8
9
193