Operations In The Channel Display Screen - RSS M-380 Owner's Manual

MATRIX channel operations
Attenuator adjustments
Use the PREAMP area of the CHANNEL EDIT section to adjust the
attenuator.
fig.ChEdtPreamp.eps
1.
Use the GAIN dial to adjust the attenuator.
Adjusting the left/right output balance
This operation is performed in the PAN area of the CHANNEL EDIT section.
This is valid for stereo-linked MATRIX channels.
fig.ChEdtPan.eps
1.
Use the PAN knob to adjust the balance.
You can make fine adjustments by holding down [SHIFT] while
you operate the knob.
Sending the audio signal from an
AUX bus
This operation is performed in the AUX SENDS area of the
CHANNEL EDIT section.
fig.ChEdtAux.eps
68
1.
Press AUX SELECT [1]–[16] to select the send-source AUX
bus
2.
Use the SEND LEVEL knob to adjust the amount of signal
sent to the MATRIX bus.
You can make fine adjustments by holding down [SHIFT] while
you operate the knob.
You can't use SENDS ON FADER to adjust the send amount
from AUX channels to an MATRIX bus.
Operations in the CHANNEL
DISPLAY screen
The parameters of the MATRIX channels can be operated in the
CHANNEL DISPLAY screen.
CHANNEL DISPLAY screen
fig.ScrChDispMtxGuide.eps
1 3
2
1.
Attenuator
fig.ScrMtxATTGuide.eps
b
a
a. ATT knob
This adjusts the channel's input level in the range of -48 dB–0
dB (6 dB steps).
b. OL (Overload) indicator
This will light red when the output of the attenuator exceeds the
OVER Lev setting specified in the METER SETUP popup (p. 96).
Normally, you can leave the attenuator at 0 dB. If an input is
overloading, you can avoid the overload by adjusting the
attenuator.
4 5
6
7
8