RSS M-380 Owner's Manual page 80

Dynamics
Accessing the COMPRESSOR popup
1.
In the fader module section, press a [SEL] button to select
the desired channel.
2.
In the COMP area of the CHANNEL EDIT section, press
[DISP].
fig.PopComp.eps
The COMPRESSOR popup will appear.
Selecting the key-in signal for the
compressor
fig.CompKeyInFlow.eps
FILTER GATE COMP
To Comp
KEY-IN
Comp
KEY-IN
The key-in signal used by the compressor is taken from immediately
after the gate of CH1–CH48.
To select the key-in signal, use the KEY-IN SELECT popup.
1.
Move the cursor to the KEY-IN SELECT popup button, and
press [ENTER].
The KEY-IN SELECT popup will appear.
fig.PopKeyInguide2.eps
A
A.Current key indication
This indicates the current key.
B.Assigned dynamics indication
This indicates the dynamics to which the KEY-IN SELECT
popup applies.
80
B C
C.Key-in signal select buttons
Use these to select the channel that will be used as the key-in
signal.
In the KEY-IN SELECT popup, the function buttons perform the
following operations.
[F1 (CH 1–24)] Displays CH1–CH24 as the key-in
signal select buttons.
[F2 (CH 25–48)] Displays CH25–CH48 as the key-in
signal select buttons.
[F6 (SELECT SELF)] Selects the channel itself as its own
key-in signal.
[F8 (CLOSE)] Closes the popup.
2.
Press [F1 (CH 1–24)] or [F2 (CH 25–48)] to view the desired
key-in signal select buttons.
3.
Move the cursor to the desired key-in signal select button,
and press [ENTER] to select it.
4.
Press [F8 (CLOSE)] to close the popup.
If you want to use the channel itself as its own key-in signal,
press [F6 (SELECT SELF)].
Listing the COMPRESSOR states
1.
Access the COMPRESSOR popup.
fig.PopComp.eps
2.
Press [F1 (OVERVIEW)] to access the COMPRESSOR
OVERVIEW popup.
fig.ScrCompOverviewGuide.eps
A
B
A.Overview
This shows the overall compressor status for CH1–CH48.