Assigning Sources To Groups (Source Assign Settings) - RSS M-380 Owner's Manual

Management of the M-48 live personal mixer
4.
Press [F8 (OK)].
fig.ScrM48CopyMix_Conf.eps
A confirmation message will ask you to confirm the copy
operation.
In this example, the MAIN L/R mix is being copied.
5.
Press [F8 (COPY)]; the mix levels you selected in step 3 will
be copied to the levels of the corresponding sources, and
the popup will close.
Pressing [F7 (CANCEL)] will cancel the operation.
Assigning sources to groups
(Source Assign settings)
This assigns source 1 through 40 to group 1 through 16 for operating
the M-48 panel. You make assignments to the groups using the M-48
SOURCE ASSIGN popup.
Accessing the M-48 SOURCE
ASSIGN popup
1.
Access the desired M-48 SETUP popup (p. 190).
fig.ScrM48Setup.eps
2.
Press [F4 (SOURCE ASSIGN)].
The M-48 SOURCE ASSIGN popup will appear.
fig.ScrM48SrcAsgn_Guide.eps
B
A
C
A.Current Assign indication
196
This indicates the group to which the source at the cursor
location is assigned.
B.Target M-48 indication
This indicates the unit name of the M-48 that is the target of
the M-48 SOURCE ASSIGN popup.
C.Assignment grid
This grid lets you assign sources to groups (Knobs 1–16).
fig.ScrM48AsgnGrid_Guide.eps
Source indication Assignment symbol
•Source indication
This indicates the number and name of each source.
•Group indication
This indicates the number and name of each group (Knob).
•Assignment symbol
This symbol is shown at the intersection of each currently
assigned source and group.
To change an assignment, move the cursor to the location where
the desired source and group intersect, and press [ENTER].
A source can be assigned only to one group. You cannot assign
the same source to multiple groups.
Sources that are not assigned to a group cannot be controlled
from the M-48's panel. If you don't want these sources to be
output from the M-48, use the source level/pan settings (p. 193)
to set their level to -Inf dB.
In the M-48 SOURCE ASSIGN popup, the function buttons
perform the following tasks.
Button Operation
[F1 (LAYER 1-8)] Displays groups 1–8.
[F2 (LAYER 9-16)] Displays groups 9–16.
[F7 (CLEAR ALL)] Clears the source assignment
settings.
[F8 (CLOSE)] Closes the popup.
Group indication
See
page
p. 197