Basic Operation; Basic Panel Operations - RSS M-380 Owner's Manual

Basic operation

Basic panel operations

Selecting the channel layer
fig.LayerBtn.eps
Use the buttons of the Layer section to select the channel layer that
will be controlled by the fader module section. Each channel layer
assigns the following channels to the fader module section.
Channel layer Channels
AUX13-16/MTX AUX13–AUX16, MATRIX1–MATRIX8
(or AUX13–AUX16, DCA1–DCA8)
AUX1-12 AUX1–AUX12
CH37-48 CH37–CH48
CH25-36 CH25–CH36
CH13-24 CH13–CH24
CH1-12 CH1–CH12
If the user preference AUX/MTX LAYER (p. 155) is set to
"4Auxes + 8DCA," the AUX13-16/MTX layer button will assign
AUX13–AUX16 and DCA1– DCA8 to the fader module section.
For more information about the USER layer button, refer to
"Switching to the user layer" (p. 153).
34
Operations in the CHANNEL EDIT
section
Here's how to edit the channel parameters.
1.
In the fader module section or main fader module, press a
[SEL] button to select the channel that you want to control.
fig.SELBtn.eps
[ SEL ]
2.
In the CHANNEL EDIT section, press [CH DISP].
fig.ChDispBtn.eps
CH DISP
3.
The CHANNEL DISPLAY screen will appear. Use the
controllers of the CHANNEL EDIT section to edit the values.
fig.ScrChDisp.eps
You can make adjustments in finer increments by holding down
[SHIFT] while you operate the CHANNEL EDIT section's knobs
or the value dial.
If you want to edit channel parameters that are not shown in the
CHANNEL DISPLAY screen, you can press the [DISP] button
in each area of the CHANNEL EDIT section to access a popup
that lets you make settings in greater detail.
If you've selected the CHANNEL SELECT item "CHANNEL
DISPLAY follows CH SELECT button" in User Preference (p.
155), pressing a [SEL] button will cause the CHANNEL
DISPLAY screen of that channel to appear.
[SEL]