Making Settings For An M-48 Unit - RSS M-380 Owner's Manual

Management of the M-48 live personal mixer
Making settings for an M-48
unit
Accessing the M-48 SETUP popup
1.
Access the M-48 MANAGER popup (p. 187).
fig.ScrM48Manager.eps
2.
In the M-48 list, move the cursor to the desired target
M-48 unit and press [F2 (SETUP)].
The M-48 SETUP popup will appear.
fig.ScrM48Setup_Guide.eps
A
B
C
D
A.Target M-48 indication
This indicates the M-48 unit that is the target of the settings.
This shows the same item as the M-48 list of the M-48
MANAGER popup.
B.Version number
This indicates the version of the target M-48 unit.
System System program version
Panel Panel program version
C.SOURCE LEVEL
fig.ScrM48SrcLev0.eps
This is an overview of the source levels. The approximate
levels of sources 1–40 are shown. You can also use the value
dial to adjust the level.
190
D. GROUP MIX (VOLUME)
fig.ScrM48GrpMix0_Guide.eps
This is an overview of the group mix volumes.
a.Group name
This indicates the group name. If you move the cursor here
and press [ENTER], the NAME EDIT popup will appear,
allowing you to edit the group name. You can enter a group
name of up to six characters.
b.Volume knob
This adjusts the group's volume in a range of -Inf dB – +20.0
dB.
If no index markings are shown for a knob, this means that no
source has been assigned to that group.
In the M-48 SETUP popup, the function buttons perform the
following tasks.
Button Operation
Changes the target M-48 unit.
[F1 ( PREV UNIT)]
The target for the settings will
[F2 (NEXT UNIT )]
change according to the order
of the M-48 list in M-48 MAN-
AGER.
[F3 (SOURCE LEV/PAN)] Accesses the M-48 SOURCE
LEV/PAN popup, where you
can set the source level and
pan.
[F4 (SOURCE ASSIGN)] Accesses the M-48 SOURCE
ASSIGN popup, where you
can specify source assign-
ments.
[F5 (GROUP MIX)] Accesses the M-48 GROUP
MIX popup, where you can
make group mix settings.
[F6 (PREF)] Accesses the M-48 PREFER-
ENCES popup, where you can
make preference settings.
[F7 (SOLO CLEAR)] Clears all group solo settings.
If a group is being soloed, this
will be on (blue).
[F8 (CLOSE)] Closes the popup.
You can assign a USER button to access this popup (p. 154).
5.
View the settings of the target M-48 unit.
You can use [F1 ( PREV UNIT)] or [F2 (NEXT UNIT )] to
move to a different unit.
Group
name
Volume
knob
See
page
p. 193
p. 196
p. 198
p. 191