Compressor Operations - RSS M-380 Owner's Manual

Input channel operations
Filter operations
Use the FILTER area of the CHANNEL EDIT section to operate the filter.
fig.ChEdtFilter.eps
1.
Press [ON] to turn the filter on/off.
2.
Use the FREQ dial to adjust the frequency of the filter.
Gate/expander operations
Use the GATE area of the CHANNEL EDIT section to operate the
gate/expander.
fig.ChEdtGate.eps
1.
Holding down [SHIFT] and pressing [DISP] for the GATE
area switches the gate/expander on or off.
By pressing [DISP] you can access the GATE/EXPANDER popup,
where you can make detailed settings for the gate/expander. For
details, refer to "Gate/expander operations" (p. 73) .

Compressor operations

Use the COMP area of the CHANNEL EDIT section to operate the
compressor.
fig.ChEdtComp.eps
1.
Holding down [SHIFT] and pressing [DISP] for the COMP
area switches the compressor on or off.
By pressing [DISP] you can access the COMPRESSOR popup,
where you can make detailed settings for the compressor. For
details, refer to "Compressor operations" (p. 78).
44
Four-band EQ operations
Use the EQUALIZER area of the CHANNEL EDIT section to operate
the EQ.
fig.ChEdtEQ.eps
1.
Press [ON] to turn the four-band EQ on/off.
2.
Use the GAIN knobs to adjust the gain of each frequency
band.
3.
Use the FREQ knobs to adjust the center frequency of each
band.
4.
Use the Q knobs to adjust the Q of the LO-MID and HI-MID
bands.
You can make fine adjustments by holding down [SHIFT] while
you operate the knob.
By pressing [DISP] you can access the EQUALIZER popup,
where you can make detailed settings for the four-band EQ. For
details, refer to "Four-band EQ operations" (p. 84).
Adjusting the pan of the audio
signal sent to the MAIN L/R bus
Use the PAN area of the CHANNEL EDIT section to make these
adjustments.
fig.ChEdtPan.eps
1.
Use the PAN knob to adjust the pan.
You can make fine adjustments by holding down [SHIFT] while
you operate the knob.