RSS M-380 Owner's Manual page 49

• AUX pan slider
fig.ScrChSendField2.eps
If the AUX send destination is stereo-linked, this lets you adjust
the left/right panning of the audio signal in the range of L63–
R63. This is shown in the area of the odd-numbered AUX send.
For detailed AUX send settings, refer to "AUX send operations"
(p. 87).
Sends to the AUX used by the LCR SYSTEM as MAIN C are
indicated as "MAIN C," and cannot be operated.
fig.ScrChSendField2.eps
9.
Pan
fig.ScrChPan.eps
This adjusts the left/right panning of the audio signal sent to
the MAIN L/R bus in the range of L63–R63.
10. Group
fig.ScrChGroup.eps
This indicates whether the channel is assigned to a DCA group or a
MUTE group.
If you move the cursor to DCA GROUP or MUTE GROUP and press
[ENTER], the GROUP ASSIGN popup will appear, allowing you to
make DCA group or MUTE group assignments.
You can also access the GROUP ASSIGN popup by pressing [F5
(GROUP ASSIGN)].
Input channel operations
11. Fader
fig.ScrChFader.eps
a. Fader
This adjusts the amount sent to the MAIN L/R bus in the range
of -Inf dB– +10.0 dB.
You can make settings in finer increments by operating the
value dial while you hold down [SHIFT].
b. S button
This turns SOLO on/off for the channel.
c. M button
This turns MUTE on/off for the channel.
d. MAIN button
This turns the MAIN send on/off.
e. Channel meter
This indicates the signal level of the channel. For a stereo-linked
channel, two meters L and R are shown. The level detection
point is according to the setting in the METER screen. For
details, refer to "Editing the meter settings" (p. 96).
The function buttons have the following operations.
[F1 (LINK)] Turns channel link on/off.
[F2 (NAME EDIT)] Accesses the NAME EDIT pop-
up, where you can specify the
channel name.
[F3 (COPY)] Accesses the CH COPY popup,
where you can copy channel set-
tings.
[F4 (LIBRARY) Accesses the CH LIBRARY pop-
up, where you can use the chan-
nel library.
[F5 (GROUP ASSIGN)] Accesses the GROUP ASSIGN
popup, where you can assign the
channel to DCA groups and
MUTE groups.
[F6 (PEAK CLEAR)] Clears the level meter's peak
hold or over indication.
[F7 (ATT Ctrl)] If this is on, the target of the
GAIN knob will change to con-
trolling the channel attenuator.
[F8 (Patchbay)] Accesses the PATCHBAY
screen.
a
e
b
c
d
p. 50
p. 51
p. 52
p. 53
p. 54
p. 50
p. 90
49