RSS M-380 Owner's Manual page 189

2.
In the M-48 list, move the cursor to the NO. field of the
desired M-48 and press [ENTER].
fig.ScrM48Arrange.eps
The ARRANGE UNIT popup will appear.
3.
Use the value dial to specify the desired order for that
M-48 unit.
4.
Press [F8 (OK)].
The M-48 list will be reordered so that the selected M-48 is in
the place you specified in step 3, and the popup will close.
If you press [F7 (CANCEL)], the operation will be cancelled and
the popup will close.
The M-380 will show the connected M-48 units in the M-48 list
in the order in which the units are detected; the displayed order
is remembered so that this order can be reproduced the next
time the power is turned on.
This operation will update the display priority order as well as
the order in the M-48 list.
Muting the output of an M-48 unit
1.
Access the M-48 MANAGER popup (p. 187).
fig.ScrM48Manager.eps
2.
In the M-48 list, move the cursor to the MUTE field of the
desired M-48 and press [ENTER] to add a check mark.
The PHONES and LINE OUT outputs of the checked M-48
unit(s) will be muted.
If any of the M-48 units in the M-48 list have been muted, the M-
48 MANAGER popup's [F1 (MUTE CLEAR)] indication will be
on.
Management of the M-48 live personal mixer
Disabling memory operations from
the M-380 (MEMORY SAFE function)
1.
Access the M-48 MANAGER popup (p. 187).
fig.ScrM48Manager.eps
2.
In the M-48 list, move the cursor to the MEMORY SAFE field
of the desired M-48 and press [ENTER] to add a check mark.
M-48 units with a check mark will not accept Store or Recall
operations from the M-380.
When you're managing multiple M-48 units, this allows you to
prevent unintended memory operations, or to exclude specific
M-48 units when synchronizing scene memories with M-48
memories.
189