RSS M-380 Owner's Manual page 109

Using the analyzer
1.
Access the GEQ EDIT popup for the desired GEQ.
fig.ScrGEQEdit.eps
If using the 8-band parametric EQ, turn [F6 (Analyzer)] on to
display the analyzer.
2.
Use SRC to select the source for the analyzer.
• If you select SELF, the source will be the output of the channel
in which the EQ is inserted.
• If the analyzer display is too large or too small, use WINDOW
to adjust the vertical display area.
• As desired, use AVG and AVG TIMES to make settings for
averaging.
If an input channel is selected, its direct out will be the source
for the analyzer.
If an output channel is selected, its output will be the source for
the analyzer.
If you want to see the response of the sound that is actually
being produced from the speakers, set up a measurement mic,
patch it to an input channel of the M-380, and select that
channel as the source.
If the M-380 and M-380RCS (software that remotely controls the
M-380 from a PC) both attempt to display the analyzer
simultaneously, display on the M-380 will take priority. In this
case, the analyzer levels will not be shown in the M-380RCS
window.
fig.RCS_OccupyGEQ.eps
Effects and 31-band GEQ
Using the GEQ library
You can recall 31-band GEQ settings from the library, and store the
current 31-band GEQ settings in the library.
GEQ library operations are performed in the GEQ LIBRARY popup.
1.
Access the GEQ EDIT popup for the GEQ unit that is the
target of GEQ LIBRARY operations.
ig.ScrGEQEdit.eps
2.
Press [F5 (LIBRARY)].
The GEQ LIBRARY popup will appear.
fig.ScrGEQLibGuide.eps
A B
A.Applicable GEQ indication
This indicates the effect to which the GEQ LIBRARY popup applies.
B.Library data list
This is a list of the library data.
In the GEQ LIBRARY popup, the function buttons perform the
following operations.
[F1 (PRESET)] Accesses the recall-only PRESET library.
[F2 (USER)] Accesses the USER library, which al-
lows you to recall or store data.
[F3 (PREVIEW)] Previews (auditions) the library data
that is selected in the list.
[F4 (RECALL)] Recalls the library data that is selected
in the list.
[F5 (STORE)]* Stores the current settings to the li-
brary item that is selected in the list.
[F6 (LOCK)]* Locks the library data that is selected
in the list.
[F7 (NAME EDIT)]* Accesses the NAME EDIT popup,
where you can edit the name of the
user library data selected in the list.
[F8 (CLOSE)] Closes the popup.
* Available only for the User library.
109