Table of Contents
Advertisement
Gate
fig.PopGateGuide2.eps
a. THRESH knob
This adjusts the threshold level in a range of -80.0 dB–0.0 dB.
b. RANGE knob
This adjusts the RANGE in a range of -Inf dB–0.0 dB.
c. ATTACK knob
This adjusts the ATTACK time in a range of 0.0 ms–800.0 ms.
This is the time from when the input signal exceeds the
threshold level until the gate opens completely.
d. RELEASE knob
This adjusts the RELEASE time in a range of 0 ms–8000 ms. This
is the time over which the gate reaches its maximum effect after
the HOLD time has elapsed.
e. HOLD knob
This adjusts the HOLD time in a range of 0 ms–8000 ms. This is
the time from when the input signal falls below the threshold
level until the gate begins closing.
Expander
fig.PopExpGuide.eps
a. THRESH knob
This adjusts the threshold level in a range of -80.0 dB–0.0 dB.
A
B
C
D
E
A
B
C
D
E
b. RATIO knob
This adjusts the RATIO in a range of 1.00:1–INF:1 (14 steps).
c. KNEE knob
This adjusts the KNEE in a range of HARD or SOFT1–SOFT9
(ten steps). The way in which the expander is applied to the
region near the threshold level can be adjusted between steep
(HARD) and gentle (SOFT9).
d. ATTACK knob
This adjusts the ATTACK time in a range of 0.0 ms–800.0 ms.
This is the time from when the input signal exceeds the
threshold level until the expander effect disappears.
e. RELEASE knob
This adjusts the RELEASE time in a range of 0 ms–8000 ms. This
is the time from when the input signal falls below the threshold
level until the expander effect reaches its maximum.
Ducking
fig.PopDuckGuide.eps
a. THRESH knob
This adjusts the threshold level in a range of -80.0 dB–0.0 dB.
b. RANGE knob
This adjusts the RANGE in a range of -Inf dB–0.0 dB.
c. ATTACK knob
This adjusts the ATTACK time in a range of 0.0 ms–800.0 ms.
This is the time from when the input signal exceeds the
threshold level until the ducking effect reaches its maximum.
d. RELEASE knob
This adjusts the RELEASE time in a range of 0 ms–8000 ms. This
is the time over which the ducking effect disappears after the
HOLD time has elapsed.
e. HOLD knob
This adjusts the HOLD time in a range of 0 ms–8000 ms. This is
the time from when the input signal falls below the threshold
level until the ducking effect begins to disappear.
Dynamics
a
b
c
d
e
75
Advertisement
Chapters
Table of Contents
