RSS M-380 Owner's Manual page 194

Management of the M-48 live personal mixer
5.
AUX button
If this is on, the post-fader signal will be mixed to the AUX bus.
(Refer to p. 191 for enabling the AUX output mode.)
6.
Meter
This indicates the input level of the source.
7.
PAN knob
This adjusts the source's panning in a range of L63–C–R63.
8.
Fader
This adjusts the source's level in a range of -Inf dB – +10.0 dB.
9.
Group
Shows a group to which a source is assigned.
If a source is not assigned to any groups, that shows "--."
"Assigning sources to groups (Source Assign settings)" (p. 196)
In the M-48 SOURCE LEV/PAN popup, the function buttons
perform the following tasks.
Button Operation
[F1 (SOURCE LAYOUT)] Switches to the SOURCE LAY-
OUT tab.
[F2 (M-380 LAYOUT)] Switches to the M-380 LAYOUT
tab.
[F3 (COPY MIX LEVEL)] Accesses the COPY MIX LEVEL
popup, where you can copy the
M-380's mix levels to sources.
[F5 (SOURCE ON FAD- If this is on, you'll be able to use
ER)] the top panel faders to adjust
the source levels.
[F6 (MONITOR)] If this is on, the M-380's monitor
output will output the mix of
sources 1–40.
[F7 (RESET)] Resets the source level/pan set-
tings.
[F8 (CLOSE)] Closes the popup.
*1 This function cannot be used in M-380RCS (software that remotely
controls the M-380 from a PC).
In the M-48 SOURCE LEVEL/PAN popup, the level meters and
the mix of sources 1–40 is monitored using the DSP resources of
the 31-band realtime analyzer. This means that in the M-380RCS
(software that remotely controls the M-380 from a PC), the level
meters in the M-48 SOURCE LEVEL/PAN popup and the 31-
band realtime analyzer are not shown, while the M-380 is
displaying the M-48 SOURCE LEVEL/PAN popup, or is using
the 31-band realtime analyzer.
194
See
page
p. 195
p. 194
p. 194
*1
p. 195
Accessing the M-48 SOURCE LEV/
PAN popup
1.
Access the desired M-48 SETUP popup (p. 190).
fig.ScrM48Setup.eps
2.
Press [F3 (SOURCE LEV/PAN)].
fig.ScrM48SrcLev1.eps
The M-48 SOURCE LEV/PAN popup will appear.
3.
Verify that the desired M-48 is shown in the target unit
indication.
If the wrong unit is selected, press [F8 (CLOSE)] to close the
popup; then re-select the target and return to step 2.
4.
Use [F1 (SOURCE LAYOUT)] or [F2 (M-380 LAYOUT)] to
select the display that you prefer.
Editing the source level/pan
settings
1.
Access the desired M-48 SOURCE LEV/PAN popup (p. 194).
fig.ScrM48SrcLev1.eps
2.
Move the cursor to the faders and pan knobs of sources 1–
40, and use the value dial to edit the values.
3.
If you want to hear the mix of sources 1–40 via the
M-380's monitor output, turn [F6 (MONITOR)] on.