Stereo-Linking Channels - RSS M-380 Owner's Manual

Input channel operations
The [F7 (ATT Ctrl)] setting is common to all channels CH1–48.
When the M-380 is configured as a Monitor console, it is
convenient to use the GAIN knob as an attenuator over the
shared inputs.
The [F7 (ATT Ctrl)] setting is stored in the M-380 as a system
parameter. It is not saved in scene memory.
When you press [F8 (Patchbay)] to access the PATCHBAY
screen, the PATCHBAY screen will appear with the currently
selected channel highlighted.
Accessing the CHANNEL DISPLAY
screen
1.
In the fader module section, press [SEL] to select a
channel.
2.
In the CHANNEL EDIT section, press [CH DISP] to access
the CHANNEL DISPLAY screen.
fig.ScrChDisp.eps
Pressing a different [SEL] while the CHANNEL DISPLAY
screen is shown will switch you to the display for that channel.
If you've selected the "CHANNEL DISPLAY follows CH
SELECT" button located in the CHANNEL SELECT area of
User Preference (p. 155), pressing a [SEL] will recall the
CHANNEL DISPLAY screen for that channel.
50

Stereo-linking channels

Adjacent odd-numbered and even-numbered channels can be stereo-
linked so that their parameters will have the same settings. This is
convenient when you're dealing with stereo sources.
1.
Access the CHANNEL DISPLAY screen for the channel that
you want to stereo-link.
fig.ScrChDisp.eps
2.
Press [F1 (LINK)].
A confirmation message will appear, asking you to confirm the
stereo-link operation.
The function buttons have the following operations.
[F6 (CANCEL)] Cancels the stereo-link operation
and closes the popup.
[F7 (LINK (L <- R))] The parameters of the odd-num-
bered channel will be set to the val-
ues of the even-numbered channel.
[F8 (LINK (L -> R))] The parameters of the even-num-
bered channel will be set to the val-
ues of the odd-numbered channel.
3.
Press [F7 (LINK (L <- R))] or [F8](LINK (L -> R) ] , the
channels will be stereo-linked.
Stereo-linked parameters
The following parameters are linked by stereo-link.
• Phase
• Attenuator
• Filter parameters
• Gate/expander parameters other than Key In
• Compressor parameters other than Key In
• Four-band EQ parameters
• Fader parameters
• AUX send level, send switch and send point
• Direct out point
When you enable stereo-link, the gate/expander and
compressor will operate in stereo.