RSS M-380 Owner's Manual page 143

Specifying the input source for the
USB memory recorder
By default, the input of the USB memory recorder are specified as
follows.
Input
RECORDER IN L
RECORDER IN R
The RECORDER SOURCE SELECT popup is used to specify the input.
1.
In the USB MEMORY RECORDER section, press [DISP].
fig.ScrRecorderPlay.eps
The RECORDER screen will appear.
2.
Move the cursor to the L channel of the RECORDER
SOURCE SELECT popup button, and press [ENTER].
The RECORDER SOURCE SELECT popup will appear.
fig.ScrRcdrSrcSelectGuide.eps
A
A.Current source indication
This indicates the current input source.
B.Input source channel select buttons
Use these to select the input source channel for the USB
memory recorder.
When the LCR SYSTEM is turned on, "MAIN L+C" and "MAIN
R+C" are shown for the input source channel select button.
These respectively indicate a mono mix of MAIN L and MAIN
C, and a mono mix of MAIN R and MAIN C.
3.
Move the cursor to the channel that you want to use as the
input source, and press [ENTER] to select it.
4.
Press [F8 (CLOSE)] to close the popup.
5.
Make settings for the R channel in the same way.
Input source
MAIN L
MAIN R
B
USB memory recorder
Specifying the output destination
for the USB memory recorder
By default, the output of the USB memory recorder are specified as
follows.
Output
RECORDER OUT L
RECORDER OUT R
The RECORDER DESTINATION SELECT popup is used to specify
the output.
1.
In the USB MEMORY RECORDER section, press [DISP].
fig.ScrRecorderPlay.eps
The RECORDER screen will appear.
2.
Move the cursor to the L channel of the RECORDER
DESTINATION SELECT popup button, and press [ENTER].
The RECORDER DESTINATION SELECT popup will appear.
fig.ScrRcdrDestSelectGuide.eps
B
A.Current destination indication
This indicates the current output-destination channel.
B.Output destination channel select buttons
Use these to select the output destination channel for the USB
memory recorder.
The function buttons perform the following operations.
[F1 (CH 1–24)] Displays CH1–CH24 as the output-
destination channel select buttons.
[F2 (CH 25–48)] Displays CH25–CH48 as the output-
destination channel select buttons.
[F6 (SELECT NONE)] Clears the output-destination selection.
[F8 (CLOSE)] Closes the popup.
Output destination
CH45
CH46
A
143