RSS M-380 Owner's Manual page 171

3.
Use the INTERNAL SAMPLING FREQ select buttons to
select either 44.1 kHz or 48 kHz as the sampling frequency
at which the M-380 will operate.
fig.ScrSetFreqConf.eps
A message will ask you to confirm that you want to change the
sampling frequency.
Press [F8 (SET)] to switch to the sampling frequency you
selected in step 3.
If you press [F7 (CANCEL)], the change will be cancelled.
The internal word clock setting also determines the sampling
frequency of the M-380's DIGITAL OUT connector and the
sampling frequency for recording and playback on the USB
memory recorder.
Adjusting the brightness of the
panel and display
The BRIGHTNESS field of the SYSTEM screen is used to adjust the
brightness of the panel, and display.
1.
Access the SYSTEM screen.
fig.ScrSysBrightGuide.eps
A.PANEL knob
This adjusts the brightness of the panel buttons and meters.
B.DISPLAY knob
This adjusts the brightness of the display.
2.
Move the cursor to the PANEL knob, and use the value
knob to adjust the brightness of the panel buttons and
meters.
Higher values produce greater brightness.
3.
Move the cursor to the DISPLAY knob, and use the value
dial to adjust the brightness of the display.
Higher values produce greater brightness.
A B
Other settings and functions
Adjusting the fader touch
sensitivity
To adjust the touch sensitivity of the faders, use the FADER TOUCH
SENS field of the SYSTEM screen.
1.
Access the SYSTEM screen.
fig.ScrSysTouchGuide.eps
A.SENS knob
This adjusts the touch sensitivity of the faders.
2.
Move the cursor to the SENS knob, and use the value dial to
adjust the touch sensitivity of the faders.
Higher values produce greater sensitivity.
If this is set to 0, fader touch sensitivity will be off.
If you turn [TOUCH SELECT] on in the CHANNEL EDIT
section, you'll be able to select a channel by touching its fader.
If a channel is not selected when you touch its fader, increase
the setting of the SENS knob.
If the faders are too sensitive, turn down the SENS knob.
Depending on the environment in which you're using the M-
380, fader touch sensitivity may not operate correctly, and the
fader motor may operate incorrectly while you're operating the
fader. If this occurs, use the M-380 with the SENS knob set to 0
so that touch sensitivity is turned off.
A
171