RSS M-380 Owner's Manual page 88

AUX send/MATRIX send
The color of the send level bar indicates the send point or the
status of the send switch, as follows.
Color of the Status
send level bar
Blue PRE EQ or PRE FADER send point
Green POST FADER send point
Gray Send switch is off
C.ON button
This turns the send switch on/off. The send switch turns the
signal from the channel to AUX on/off.
D.send point select buttons
These select the point from which the CH signal is sent to
AUX, from the following choices.
PRE EQ Send from the pre-EQ point.
PRE FD Send from the pre-fader point.
POST FD Send from the post-fader point
E.AUX LINK switch
This turns linking of adjacent odd-numbered/even-numbered
AUX channels on/off. If this is on, the adjacent AUX channels
will be linked.
If AUX is stereo-linked, the following parameters will be
shown for the odd-numbered AUX send.
fig.PopAuxSendField2Guide.eps
a b
a.AUX pan slider
This adjusts the left/right panning of the signal sent to the
stereo-linked AUX channels in a range of L63–R63.
b.PAN LINK button (input channels only)
This turns the PAN LINK switch on/off. If PAN LINK is on,
the pan from the channel to MAIN L/R will be linked with
the pan from the channel to the stereo-linked AUX channels.
In the AUX SENDS popup, the function buttons perform the
following operations.
Button Function
[F1 (SENDS 1-8)] Displays the sends to AUX1–AUX8.
[F2 (SENDS 9-16)] Displays the sends to AUX9–AUX16.
[F3 (ALL ON) Turns on all send switches for each send field.
[F4 (ALL OFF) Turns off all send switches for each
send field.
[F5 (UNITY) Sets the send level to 0.0 dB for the send
field at the cursor location.
[F8 (CLOSE)] Closes the popup.
When the LCR SYSTEM is turned on, a send to AUX used as
MAIN C is displayed as "MAIN C," and no operation is
possible.
88
Setting all AUX send points in a
single operations
1.
Press the [SEL] button of any channel CH1–48 to select an
input channel.
2.
In the CHANNEL EDIT section's AUX SENDS area, press
[DISP] to access the AUX SENDS popup.
fig.ScrAuxSends.eps
3.
Press [F6 (ALL CH POINTS)] to access the ALL CH SEND
POINTS popup.
fig.ScrSendPoints.eps
A
A.Send point select buttons 1–16
These buttons select the send point for AUX1–AUX16 from the
following choices.
Selection Explanation
Keep Maintains the current setting.
PRE EQ Specifies pre-EQ.
PRE FD Specifies pre-fader.
POST FD Specifies post-fader.
4.
Use the send point select buttons to select the desired send
point.
5.
Press [F8 (OK)]; the AUX send points you selected in step 4
will be assigned for all channels CH1–CH48 in a single
operation, and the popup will close.
Pressing [F7 (CANCEL)] will cancel the operation and close the
popup.