RSS M-380 Owner's Manual page 195

4.
If you want to use the M-380's top panel faders to control
the levels, turn [F5 (SOURCE ON FADER)] on.
The display in the M-380 LAYOUT tab will switch in tandem
with the M-380's channel layer buttons.
Resetting the source level/pan
settings
1.
Access the desired M-48 SOURCE LEV/PAN popup (p. 194).
fig.ScrM48SrcLev1.eps
2.
Press [F7 (RESET)].
fig.ScrM48SrcLevClr_Conf.eps
A confirmation message will ask you to confirm the operation.
3.
Press [F8 (RESET)] to reset the source level/pan settings
and close the popup.
The parameters of each source will be set to the following
values.
Parameter Value
AUX switch ON
PAN C
LEVEL - Inf
Pressing [F7 (CANCEL)] will cancel the operation and close the
popup.
dB
Management of the M-48 live personal mixer
Copying the M-380's mix levels to
the source levels
Here's how you can copy the M-380's mix levels (the levels from
channels to MAIN or to an AUX) to the level of the corresponding
source.
1.
Access the desired M-48 SOURCE LEV/PAN popup (p. 194).
fig.ScrM48SrcLev1.eps
2.
Press [F3 (COPY MIX LEVEL)].
fig.ScrM48CopyMix_Guide.eps
A
B
The COPY MIX LEVEL popup will appear.
A.Mix level select buttons
These select the mix from which the levels will copied: AUX1–
AUX16 or MAIN L/R.
If you select MAIN L/R, the sends from AUX to MAIN will also
be included.
B.Copy PAN (All center on MONO MIX) button
If this is on, the send pan will also be copied.
If you use the mix level select buttons to select a mono mix, the
pan settings will be in the center.
3.
Use the mix level select buttons to select the mix levels that
you want to copy.
If you also want to copy the pan, turn the Copy PAN (All
center on MONO MIX) button on.
195