RSS M-380 Owner's Manual page 167

V-LINK settings
To make V-LINK settings, use the V-LINK tab of the REMOTE
popup.
1.
In the SETUP section, press [SYSTEM] to access the
SYSTEM screen.
fig.ScrSystem.eps
2.
Press [F4 (REMOTE)].
fig.ScrSysRemote.eps
The REMOTE popup will appear.
3.
Press [F3 (V-LINK)].
fig.ScrSysRmtVLnkGuide.eps
A B
The V-LINK tab will appear.
A.V-LINK button
Turns the V-LINK function on/off.
B.Dev ID knob
This specifies the device ID of the M-380 in a range of 1–32.
This setting is common to the MIDI tab, the USB MIDI tab,
and the V-LINK tab.
C
C.SOURCE field 1–8
Here you can specify the channels that will correspond to V-
LINK sources 1–8, and the maximum level and minimum
level for each channel.
fig.ScrSysRmtVLSrcGuide.eps
b a c
a.V-LINK SOURCE CHANNEL SELECT popup button
This accesses the V-LINK SOURCE CHANNEL SELECT
popup, where you can select the channel that corresponds to
each source.
b.MaxLev knob
This specifies the level when the source level is at the
maximum (100%), in a range of -Inf dB–+10.0 dB.
c.MinLev knob
This specifies the level when the source level is at the
minimum (0%), in a range of -Inf dB–+10.0 dB.
4.
Move the cursor to the Dev ID knob and specify the device
ID.
5.
Move the cursor to the V-LINK SOURCE CHANNEL SELECT
popup button for the desired source, and press [ENTER].
fig.ScrSysVlnkSrcSel.eps
A B
The V-LINK SOURCE CHANNEL SELECT popup will appear.
A.Current V-LINK source channel indication
This indicates the current V-LINK source channel.
B.Applicable V-LINK source indication
This indicates the V-LINK source to which the settings of the
V-LINK SOURCE SELECT popup will apply.
C.SOURCE CHANNEL select buttons
These buttons select the channel that will correspond to the
source.
Remote
C
167